Redcliffe & Moreton Bay Area – Same-Day Service

Pipe Relining

DR Smith Plumbing and Roofing is based in Clontarf and works across the Redcliffe and Moreton Bay area.

15050088
QBCC licence
Redcliffe
On the peninsula
Pipe Relining
A new liner inside the old pipe
A new liner inside the old pipe

Pipe relining builds a new pipe inside an old sewer drain, so the drain can be repaired without trenching its whole length. A flexible tube soaked in resin is pressed against the inside of the damaged pipe and cured into a hard, rigid lining. It suits a drain that is cracked, or has roots or groundwater getting in at the joints, but not one that has collapsed.

Pipe relining: key facts

  • Pipe relining is minor work under Queensland’s plumbing rules, alongside clearing a blocked drain and repairing a broken or damaged pipe.
  • Minor work must be performed by a licensed person, but it needs no council permit and no Form 4. We are licensed plumbers.
  • South Australia’s plumbing regulator calls relining cured-in-place pipe: a flexible tube soaked in resin that becomes a rigid pipe once the resin cures.
  • That regulator’s published relining procedure has four camera inspections: before anything starts, after cleaning, after the liner goes in, and after the branches are reopened.
  • Unitywater’s sewer runs up to and including the inspection opening, and private plumbers are barred from construction or maintenance work inside it. A fault there is reported to Unitywater for you.

When a drain may be worth relining

  • The same drain blocks again not long after it was cleared.
  • Roots keep turning up when the drain is cleaned or filmed.
  • Basins and the shower drain slowly, and the toilet gurgles when it’s flushed.
  • There’s a sewage smell outside, along the line the drain takes.
  • A strip of ground over the drain stays damp when the rest of the yard has dried out.

Reline, dig, or just clear it

A liner needs something to line. It follows the old pipe’s shape and seals over cracks and open joints, but it can’t rebuild a pipe that has lost its shape. So the camera footage, not the symptoms, decides which of three jobs a drain needs.

Option Suits Doesn’t suit What it involves
Clear and keep clear A sound pipe blocked by wipes or fat Roots or cracks, which will catch waste again Clearing the line, then changing what goes down it
Reline Cracks, root entry and leaking joints in a pipe that still holds its shape A collapsed section, or one shifted badly out of line Access at an opening or a small pit, cleaning, lining, then reopening branches
Dig and replace Collapsed or badly offset pipe, or a section the camera can’t pass Long runs under slabs, paths or established gardens, where digging causes the most disruption Exposing the pipe, cutting out the bad section and laying new pipe

Some drains need a mix: one collapsed section dug up, and the rest of the run lined from there.

What a relining job involves

Queensland’s classification of relining doesn’t set out its steps. South Australia’s Office of the Technical Regulator does, in a plumbing advisory note. It is another state’s published procedure, not a Queensland rule, but it shows the shape of the job.

  1. A camera inspection to find out whether the pipe is suitable for lining at all.
  2. Cleaning with a high-pressure water jetter.
  3. Roughening the inside with sanding discs or wire brushes so the resin can grip, then flushing out the debris.
  4. A second camera inspection, then the liner goes in.
  5. A third camera inspection to check the liner sits correctly.
  6. Reopening each branch to its full internal size, or fitting a one-piece junction liner where it joins.
  7. A fourth camera inspection, then a water pressure test, which the note stresses for major renovations.

We go through with you which of those checks are done on your drain, and we show you the footage.

A short, straight section reached from an existing opening is the simplest kind of relining. The work grows with each branch that has to be reopened, with tight bends, and with big root masses that need cutting out first. A sag that holds water makes it harder again. A section that has collapsed, or has shifted badly out of line, can’t be lined at all, and that part has to be dug up and replaced.

Why drains crack around the bay

Two local patterns send drains toward relining. One is roots: trees and shrubs planted close to sewer pipes can cause blockages and cracked pipes. The other is wet weather. Groundwater gets into the sewer network through cracks and faulty joints, which is called infiltration. A lined section closes those gaps for its whole length.

What to know before we arrive

Queensland’s position is published. Pipe relining is minor work, which must be performed by a licensed person. Relining is not on the unregulated list either, so a sewer drain reline is work for a licensed plumber or drainer, which is what we are.

Before you agree to relining, we go through the camera footage of your drain with you and show where the damage is. Then look around the yard. The overflow gully should sit at least seventy-five millimetres above the ground, with nothing built or planted over it. Downpipes should run to stormwater, not into the sewer.

Have ready how often the drain has blocked, what came out last time, any earlier footage or reports, and where the big trees are. Mention paths, decks or slabs over the drain line, because they’re what relining is meant to save.

Relining is planned work, and the camera comes first. If sewage is coming up inside or out of the gully, the drain gets cleared first, and the relining decision comes after the camera has had a proper look.

Because relining is minor work, no Form 4 is registered, so there is no copy of one to expect. Instead we give you the final camera footage, showing the liner and every branch open. In South Australia, liners must be WaterMarked to a technical specification, and we confirm that the liner product carries WaterMark certification.

The law ends where it began. In Queensland, relining a drain is minor work that must be done by a licensed plumber or drainer, with no permit beforehand and no Form 4 afterwards.

Relining, camera inspections and trenchless repair

A drain camera inspection comes first, and decides whether a drain can be lined at all. Trenchless sewer repair is the wider choice between digging and no-dig methods, and relining is one of the no-dig options. Sewer line repairs cover the sections that are too far gone to line and have to be dug up and replaced.

If a drain at your place keeps blocking and you’d like to know whether it can be lined, call DR Smith Plumbing and Roofing on 0483 965 800. We work from Clontarf on drains around Redcliffe and through Moreton Bay.

Pipe Relining
Call 0483 965 800Request a quote
QBCC 15050088

Common questions

Call if your question is not covered here.

Usually far less than replacing the drain would need. The liner goes in through an inspection opening or cleaning eye where one sits in the right spot. Where there isn’t one, a small pit is dug at one end to reach the pipe. A camera inspection beforehand shows which applies, and whether any collapsed section has to be dug up anyway.

It covers them at first. The published procedure then has each branch reopened to its full internal size from inside the lining, or a one-piece junction liner fitted where it meets the drain. A camera inspection follows to confirm the condition of every branch, and we go through that footage with you when the work is finished.

It depends on the job. The length of the lined section, the number of branches to reopen, and how much root and debris has to be cleared first all change it. The resin also has to cure before the new pipe is rigid, and the drain is out of use while that happens. We tell you when to hold off on flushing and showers.

No. The liner needs a pipe that still holds its shape. A section that has collapsed, or has shifted badly out of line, has to be dug up and replaced, and a camera inspection shows that beforehand. Tight bends and many branches don’t rule a drain out, but they make the job bigger.

No. Pipe relining is minor work. That means it must be done by a licensed person, but it needs no council permit and no Form 4 is registered afterwards. If a collapsed section is dug up and replaced as part of the same job, that part may be classed differently, and we tell you how.

Where we work

DR Smith Plumbing and Roofing is based in Clontarf on the Redcliffe peninsula and works across the Moreton Bay area. For Pipe Relining in Clontarf or one of the suburbs below, call 0483 965 800. The same number covers plumbing and roofing jobs.

Map of our Clontarf base. Opens Google Maps

Click map view in Google maps

Roofing services

Steel roof repairs, re-roofing and gutters from the team you already call for plumbing, based in Clontarf.

See all roofing services

SPEAK TO US TODAY!

We look after both your plumbing and your roofing, so there is one number to call for either job: 0483 965 800.