Redcliffe & Moreton Bay Area – Same-Day Service

Gas Fitting and Repairs

DR Smith Plumbing and Roofing is based in Clontarf and works across the Redcliffe and Moreton Bay area.

15050088
QBCC licence
Redcliffe
On the peninsula
Gas Fitting and Repairs
If you smell gas
If you smell gas

Gas fitting is the work on the pipes, valves and connections that carry gas from your meter or bottles to the cooktop, oven, heater and hot water system. You need it when you add, move or swap a gas appliance. Call us without delay if you can smell gas or a flame isn’t burning the way it should.

Key facts about gas work in Queensland

  • Only a licensed gasfitter can carry out gas work.
  • Gas work includes installing, removing, altering, repairing, servicing, testing or certifying the gas system.
  • When a gasfitter completes an installation, a gas system compliance certificate is issued through the RSHQ Portal, with the original copy going to the owner.
  • Most gas installations no longer need a physical compliance plate on the appliance, though caravans still do.
  • Bottled gas is heavier than air and can pool in low spots and drains, while natural gas is lighter and tends to rise.

Signs you need a gas fitter

  • A rotten-egg smell near the meter, the bottles or an appliance. Gas is given that smell on purpose so a leak gets noticed.
  • A faint smell that hangs around a new or moved appliance. Treat it as a leak until it has been checked.
  • A flame that flickers, sputters or won’t burn steadily.
  • A burner that won’t light within a few clicks. Stop clicking and call us.
  • An appliance that was moved or swapped and never tested for leaks afterwards.
  • A new cooktop, oven, heater or outdoor barbecue point you want connected or moved.

How gas reaches the burner, and where it escapes

On mains gas, the supply comes up through a meter and regulator beside the house. On bottled gas, a regulator screwed onto the cylinders does the same job of bringing the pressure down. From there, rigid pipe runs under the floor, through the walls or along the outside to each appliance, ending at an isolating valve, a union or a bayonet fitting.

Leaks usually show up at joints, hoses and regulators rather than along a straight run of pipe. Flexible hoses can crack or corrode, seals in bayonet and union fittings can perish, and a pipe can be knocked by a mower, a spade or a car.

A flame problem is a different question from a leak. A flame that won’t stay steady can mean the supply is running low, or that the appliance is faulty or set up wrongly. An igniter that won’t catch within a few clicks may mean the appliance itself is faulty.

What a gas job involves

A gas job starts with what the household has noticed. We look over the appliance, its connection and the supply side, from the meter or bottles through to the regulator. Bottled gas settles in low spots and drains, while mains gas rises and spreads out, which suggests where to look first. With the gas turned off, we put a gauge on the line to see whether it holds pressure. If the reading drops, we check the joints one by one with leak detection spray until bubbles show where the gas is getting out.

Failed hoses, seals and regulators are normally replaced rather than patched. Where a length of old pipe has failed, we cut it out and run new pipe in its place.

New work is planned as the shortest sensible run from the meter or bottles to the appliance. The pipe can go under the floor, through the wall, through the roof space or along the outside of the house.

At the end, we test the line again and clear the air out of it, then light every burner and check the flame.

Mains gas and bottled gas compared

Mains (natural) gas Bottled gas (LPG)
Where it comes from A meter fed from the street network Cylinders on a stand or in a cage beside the house
How a leak behaves Lighter than air, tends to rise and disperse in the open Heavier than air, can pool in low areas and drains
Where you turn it off The valve at the meter The valve on top of each cylinder
Refilling Not applicable A cylinder needs a valid ten-year test stamp before it can be refilled
Copy of the compliance certificate Owner, plus the network operator Owner

What makes a gas job bigger or smaller

  • Access. Pipe buried in a slab or hidden in a wall takes longer to reach than pipe you can see.
  • Demand. A continuous flow hot water system is a big gas user, and added to a cooktop and heater it can leave the old pipe too small to feed them all.
  • Conversion. Swapping from bottled gas to mains means converting each appliance.
  • Distance. A long run to a new barbecue point, or one that has to pass under paving, adds time.
  • Where the bottles sit. Mention it when you ring if they are in a tight or hard-to-reach spot.

When it is an emergency

Any smell of gas is the urgent case, and the steps are in the guide below. Call triple zero immediately for a fire, an explosion or an uncontrolled leak. A burner that sputters with no smell can be booked in with us, but stop using that appliance until it’s looked at. A new point for a cooktop or barbecue is planned work.

What to know before we arrive

Gas law sets the starting point. Only a licensed gasfitter can carry out gas work. That covers every pipe and connection, from the meter or cylinder to the burner.

What you can safely do if you smell gas while you wait for us:

  • Don’t light anything, and don’t flick light switches or other electrical devices on or off.
  • Turn the appliance off, and open doors and windows.
  • If the smell stays, turn the gas off at the meter, or close the valve on top of each bottle, if it’s safe to reach.
  • Get everyone outside, especially if the smell is strong, and call from out there.
  • If you can still smell gas once the supply is off, ring triple zero.

Beyond that, leave the hoses, fittings and regulator to us.

Details that help when you call about gas:

  • Which supply the house runs on, mains gas or bottles.
  • The make and model of the appliance, from its data plate or manual.
  • Where the meter or bottles are, and where the appliance is or will go.
  • For a new appliance, the benchtop cut and the cooktop or heater on site.

A finished installation leaves you with a gas system compliance certificate. We issue it through the RSHQ Portal and give you, as the owner, the original copy. The gasfitter must provide the owner with a copy once the gas work is completed. If we find a safety concern that isn’t fixed on the spot, the owner gets a defect notice.

The same law closes the gas guide. Only a licensed gasfitter can carry out gas work, residential included. A contractor supervising or performing gasfitting must also hold a gasfitting occupational licence issued through Resources Safety and Health Queensland.

Gas fitting next to the plumbing jobs around it

  • Hot water system installation joins water and gas when the new system burns gas, so the plumbing and the gas connection are both part of the job.
  • Kitchen plumbing handles the water in and the waste out at the sink, while the cooktop’s gas connection is gas fitting.
  • Emergency plumbing covers burst pipes and overflowing drains, where the first step is the water meter rather than the gas valve.

If you’re planning a new gas appliance or something about your gas doesn’t seem right, call DR Smith Plumbing and Roofing on 0483 965 800. Our base is Clontarf, and we work in homes across Redcliffe and the Moreton Bay area.

Gas Fitting and Repairs
Call 0483 965 800Request a quote
QBCC 15050088

Common questions

Call if your question is not covered here.

Leave it to us. Even a straight swap means undoing a gas joint, remaking it and testing it for leaks before the burners are lit. Installing and altering are gas work for a licensed gasfitter. Have the benchtop cut and the cooktop on site before we arrive, so the connection, leak test and first lighting can be done together.

No. Portable outdoor heaters must never be used indoors or in semi-enclosed areas. Used that way, they can produce large amounts of carbon monoxide. A patio with blinds or walls around it is therefore not a safe spot. Use the heater where the air can move freely around it.

Yes. We run a line from the meter or the bottles to a bayonet fitting on an outside wall or under the patio. The barbecue then clips on with a hose instead of running off its own small bottle. How far the line has to go, and what it has to pass under, decides the size of the job.

After an installation, yes. We issue a gas system compliance certificate through the state’s RSHQ Portal, and the owner gets the original copy. If the house is on mains gas, the network operator is sent one too. Keep yours with the appliance manuals and the receipt for the work.

Only if it’s in test. Every cylinder needs a valid ten-year test stamp to be refilled, and one that is out of test shouldn’t be filled. Store spare cylinders in a secure place away from heat and anything that could ignite them.

Where we work

DR Smith Plumbing and Roofing is based in Clontarf on the Redcliffe peninsula and works across the Moreton Bay area. For Gas Fitting and Repairs in Clontarf or one of the suburbs below, call 0483 965 800. The same number covers plumbing and roofing jobs.

Map of our Clontarf base. Opens Google Maps

Click map view in Google maps

Roofing services

Steel roof repairs, re-roofing and gutters from the team you already call for plumbing, based in Clontarf.

See all roofing services

SPEAK TO US TODAY!

We look after both your plumbing and your roofing, so there is one number to call for either job: 0483 965 800.