Redcliffe & Moreton Bay Area – Same-Day Service

Kitchen Plumbing Services

DR Smith Plumbing and Roofing is based in Clontarf and works across the Redcliffe and Moreton Bay area.

15050088
QBCC licence
Redcliffe
On the peninsula
Kitchen Plumbing Services
Under the kitchen sink
Under the kitchen sink

Kitchen plumbing covers the water coming into your sink and dishwasher and the waste going out. That means the mixer tap and its hoses, the small isolating valves under the sink, and the trap and drain below them. Call us when the sink blocks or drips, the cupboard floor gets wet, or something new needs connecting.

Key facts about kitchen plumbing in Queensland

  • Replacing a tap is work that needs a licensed person.
  • Changing a jumper valve or washer inside a tap is on the short list of plumbing work that is unregulated.
  • Installing or relocating fixtures in an existing house is notifiable work, reported to the QBCC.
  • Major kitchen renovations are notifiable work, with a Form 4 lodged within ten business days.
  • Oil from the fry pan cools, hardens and lines your pipes, then traps food scraps and coffee grounds.
  • Only a licensed gasfitter can carry out gas work, including installing, removing or altering the gas system.

What goes wrong at the kitchen sink

  • The sink empties slowly or gurgles as it drains.
  • A sour smell coming up from the plughole.
  • A damp, stained or swollen cupboard floor under the sink.
  • A spout that keeps dripping after the tap is off.
  • Weak flow at the kitchen mixer when the other taps are fine.
  • Water left sitting in the bottom of the dishwasher.

How the plumbing under a kitchen sink works

Two flexible hoses run from small isolating valves on the hot and cold pipes up to the mixer tap. They sit under full mains pressure all the time, even when the tap is off. Below the bowl, the waste drops into a trap, a bend that always holds a little water so drain smells can’t rise into the kitchen. From the trap, the waste runs into the drain in the wall or floor.

The dishwasher shares that waste. Its drain hose joins the sink waste above the trap, and its supply comes off its own isolating tap. A drain hose that loops up high under the bench stops dirty sink water running back into the machine.

Most kitchen faults come from a few places. A slow sink is usually set fat and food further along the pipe, or a trap packed with scraps. A wet cupboard is usually a loose trap nut, a perished washer or a hose rusting through. A dripping spout means worn parts inside the tap. Weak flow at one mixer often comes from grit in the aerator or a hose that has kinked.

Under the sink, step by step

For a new mixer tap, we turn the water off at the isolating valves, undo the hoses and take the old tap out from underneath. The new tap goes in and its hoses are connected to the valves. With the water back on, we flush the aerator to clear any grit, then watch every joint for drips.

For a blocked sink, our first step is working out whether the block is in the trap right under the bowl or further along the drain. A trap packed with scraps comes apart and gets cleaned out. Further along, a build-up of set fat and food has to be cleared from inside the pipe.

We dry off a wet cupboard floor, then run the tap and sink in turn to see which joint gives itself away. Then we replace the worn part.

A dishwasher gets its own isolating tap on the water supply. Its drain hose loops up high under the bench before it joins the sink waste.

Common kitchen jobs and where the law puts them

Job What’s involved Category on the QBCC and Council lists
New washer in an old tap A worn washer or jumper valve replaced Unregulated work on the QBCC list
Swap the mixer tap in place Old tap out, new tap and hoses in Minor work for a licensed plumber, nothing lodged
Clear a blocked sink Trap cleaned or pipe cleared Minor work for a licensed plumber
Move the sink or add a fixture New supply and waste pipes Notifiable work, with a Form 4
Full kitchen renovation Rough-in before cupboards, fit-off after Notifiable work, with a Form 4

What makes a kitchen job bigger or smaller

  • A tap swap with working isolating valves is quick.
  • No isolating valves means the water goes off at the meter for the whole house during the work.
  • Seized nuts and corroded pipes behind the cupboard add time.
  • A full renovation is usually two stages: pipes before the cupboards go in, and connection of the sink, tap and dishwasher after.
  • Moving the sink or dishwasher means new supply and drain pipes.
  • Cutting a benchtop for a new sink is cabinet work, done before we arrive.

Kitchen leaks that need a call now

A hose that has burst or is spraying under the sink is urgent. Turn the isolating valve on that hose clockwise until it stops, or turn the water off at the meter, then ring us. A wet cupboard floor needs attention soon, before the cabinet swells. A dripping spout or a slow sink can be booked in.

What to know before we arrive

Kitchen plumbing law in brief. Changing a washer or jumper valve in a tap is unregulated work. Replacing a tap is work for a licensed person, which is what we are. Moving a sink or adding a fixture is notifiable work.

Safe checks under the kitchen sink while you wait for us:

  • Empty the cupboard, shine a torch on the pipes and run the tap, then the sink, watching the hose connections and the trap for drips.
  • Look for damp or swelling in the cupboard floor.
  • If only the kitchen mixer is weak, note whether it’s the hot side, the cold side or both.
  • Turn the isolating valves under the sink off if a hose is leaking.
  • Keep fat out of the drain. Wipe pans with paper towel, tip used oil into a jar for the bin, and use a sink strainer to catch scraps and coffee grounds.

Leave the job of undoing hoses, valves or pipes to us. A hose that’s done up crooked or too tight can give way inside the cupboard later, so we make each connection up properly.

Handy to have when you ring us about the kitchen:

  • The make and model of the tap, or the new one if you’ve bought it.
  • A photo of the cupboard under the sink.
  • How long the tap has been dripping or the floor has been wet.
  • For a renovation, the cabinet plan showing where the sink and dishwasher go.

A finished job leaves you with a tap that carries the WaterMark, isolating valves you can turn, and a dry cupboard with the water on. A three or four-star kitchen tap still gives enough flow to fill a pot. Where a sink was moved or the kitchen renovated, you receive a copy of the Form 4.

Queensland’s licensing law closes the kitchen guide. Work outside the short unregulated list must be done by an appropriately licensed person, so the water and waste side is for a licensed plumber. Only a licensed gasfitter can carry out gas work, such as connecting a cooktop.

Kitchen plumbing beside dishwashers, taps and disposers

For a sink that’s slow, a drip that won’t stop, or a new tap or dishwasher to connect, call DR Smith Plumbing and Roofing on 0483 965 800. We’re a Clontarf business working across Redcliffe and the Moreton Bay area.

Kitchen Plumbing Services
Call 0483 965 800Request a quote
QBCC 15050088

Common questions

Call if your question is not covered here.

Cooking fat and oil go down warm and runny, then cool and set on the pipe walls like candle wax. That sticky layer catches scraps and coffee grounds until the pipe closes up. Clearing it fixes the block in front of you, but it builds back if fat keeps going down. A jar for used oil and a strainer in the plughole stop most of it.

Start with the sink. The dishwasher drains into the same trap, so a partly blocked sink can stop it emptying. A drain hose with no high loop under the bench can also let sink water run back into the machine. If the sink is slow as well, the block is the likely cause, and we clear it.

Not always, but old ones deserve a close look. The hoses sit under mains pressure day and night, and they corrode or perish out of sight in the cupboard. We replace worn hoses at the same time as the tap. Old hoses on a new tap are a weak link you can’t see once the cupboard is full again.

Replacing a tap is work that has to be done by an appropriately licensed person, and that is the work we do. The washer or jumper valve inside a tap is different, as it is on the unregulated list. A new mixer also means remaking two pressure hoses inside a closed cupboard.

A major kitchen renovation does. It is notifiable work, so we lodge a Form 4 with the QBCC within ten business days of finishing and give you a copy. Swapping a tap or sink in the same place is minor work, which needs a licensed plumber but nothing lodged.

Where we work

DR Smith Plumbing and Roofing is based in Clontarf on the Redcliffe peninsula and works across the Moreton Bay area. For Kitchen Plumbing Services in Clontarf or one of the suburbs below, call 0483 965 800. The same number covers plumbing and roofing jobs.

Map of our Clontarf base. Opens Google Maps

Click map view in Google maps

Roofing services

Steel roof repairs, re-roofing and gutters from the team you already call for plumbing, based in Clontarf.

See all roofing services

SPEAK TO US TODAY!

We look after both your plumbing and your roofing, so there is one number to call for either job: 0483 965 800.