Redcliffe & Moreton Bay Area – Same-Day Service

Water Pipe Replacement

DR Smith Plumbing and Roofing is based in Clontarf and works across the Redcliffe and Moreton Bay area.

15050088
QBCC licence
Redcliffe
On the peninsula
Water Pipe Replacement
Which water pipe is it?
Which water pipe is it?

Water pipe replacement means taking out the old pipe that carries water from the meter to the house, and often the pipes inside that feed the taps. New polyethylene or copper goes in its place. It’s usually needed when old galvanised pipe has rusted from the inside, or when leaks keep turning up along the same run.

Water pipe replacement key facts

  • Replacing galvanised water supply pipework with another type, such as polyethylene, is notifiable work.
  • Replacing a short section of broken water pipe is minor work, provided the new piece doesn’t extend too far beyond the break.
  • Unitywater describes galvanised pipe as grey, usually about one inch across, and often rough, scaly or rusty.
  • If a home’s plumbing hasn’t been upgraded in the last forty years, it likely has galvanised pipes.
  • Polyethylene and copper are the replacement materials for old galvanised pipe.

Signs the old pipe is giving out

  • Brown or rusty water first thing in the morning that clears once the tap has run.
  • A metallic taste, bits floating in the water, or tap aerators that keep clogging.
  • Pressure that has slowly dropped at every tap, not just one.
  • Rust stains in the basin, the toilet bowl or the washing machine.
  • Leaks turning up more than once along the same length of pipe.

Why old water pipe fails

Galvanised pipe is zinc-coated steel, and over the years it rusts from the inside. The oxidised iron can block the pipe. The crust narrows the bore, so less water gets through and pressure falls at every tap. Bits of that crust break off and show up as brown water, floating flakes and stains. A blocked water filter is another sign.

Copper fails differently: it can fail as a pinhole. A single failure points to a repair. Repeated failures along one run point to replacing it.

How a water service is replaced

The job starts by tracing the pipe from the meter to the house, then checking what feeds the kitchen, bathroom, laundry and hot water system. Where nobody can tell how bad galvanised pipe is inside, we cut out a short length and look at the inside before deciding.

Before we dig, we find the other services buried along the route, such as power, gas and phone lines. Then the water goes off at the meter. The new pipe joins on at the meter outlet and runs to the house in a trench, along the old line or a better one.

Inside, the runs to each fixture are re-piped, or joined onto pipes that are still sound. With everything connected, the rust and grit are flushed out, the new pipe is pressure tested and every joint is checked for weeping. Each tap is opened until it stops coughing air and the water runs clear, and then the trench is backfilled.

Repair one section or replace the run

Repair a section Replace the run
Suits One break or leak in pipe that is otherwise sound Galvanised pipe rusting along its length, repeat leaks, low pressure everywhere
The work Cut out the damaged piece and join in a new length New poly or copper from the meter outlet to the house, often with pipes inside
Queensland category Minor work for a licensed plumber with no form, provided the new piece doesn’t extend too far beyond the break Notifiable work: licensed plumber, Form 4 to the QBCC
What it fixes That leak only Rust, discoloured water and low pressure caused by that pipe

What makes a re-pipe bigger or smaller

  • How far the trench runs. A short run across open lawn is the small end of the job.
  • Where the house pipes run. Pipes in the open under a high-set house are easier to reach and swap.
  • Slabs. Pipes under concrete are harder to reach, and the route for new pipe is decided on site.
  • What’s in the way. Driveways, paths, tiled bathrooms, tree roots and other services in the trench all add work.

Low-lying ground near the bay can be hard on buried steel. Acid sulfate soils, often found in low-lying coastal areas around the bay, can corrode steel pipes. Earthworks on those soils may need development approval, which matters on a long trench.

What to know before we arrive

The law first. Under Queensland’s Plumbing and Drainage Regulation, replacing supply pipes in an existing building is notifiable work, which only a QBCC licensed plumber may do. Small items such as shower heads, filter cartridges, tap washers and cistern washers sit outside the licensed work. Cutting into or joining a water pipe is licensed work, and that is what a re-pipe is.

Checks you can make while you wait for us, without touching the pipe:

  • Find a bit of exposed pipe under the house, at a garden tap or where the pipe leaves the meter, and look at it. Galvanised pipe is grey, often rough or rusty. Copper is orange-brown, and polyethylene is black plastic.
  • First thing in the morning, fill a white container from the kitchen tap and look at the colour. Running the tap for a minute or two clears the discoloured water, but it doesn’t fix the cause.
  • Go round the house and note which taps run slow or brown, and whether it’s every tap or only some.
  • If you suspect one leak between the meter and the house rather than worn-out pipe, the water service repair page linked below sets out the meter check and the stop tap.

Leave cutting into or patching the supply pipe to us. It’s under mains pressure, and a badly made joint can let go later where you can’t see it.

Before you call, note roughly when the house was built, whether it’s high-set or on a slab, and which taps are slow or brown. Mention any leaks you’ve already had fixed. A photo of the exposed pipe helps show us what it’s made of.

A compliant re-pipe leaves you with a copy of the Form 4. We give that copy to the occupier or whoever asked for the work, within twenty business days of finishing. Most plumbing products must carry the WaterMark symbol, so you can look for it on the new pipe and fittings.

Any plumbing work outside the short unlicensed list must be performed by an appropriately licensed person.

That brings the law full circle. Repairing one damaged section is minor work and replacing the run is notifiable, and Queensland requires a licensed plumber for both. Power, gas and phone lines can share the trench route, so the digging is ours too.

Re-piping compared with nearby jobs

Replacing the pipe is the answer when the whole run is worn out. When it’s one leak between the meter and the house, a water service repair finds and fixes that spot. If the leak is hidden and nobody knows where, leak detection comes first. Pressure that’s low for other reasons is a water pressure testing job.

If the water runs brown or the pressure keeps fading, phone DR Smith Plumbing and Roofing on 0483 965 800. We’re close by in Clontarf and re-pipe older houses around Redcliffe and further afield in Moreton Bay.

Water Pipe Replacement
Call 0483 965 800Request a quote
QBCC 15050088

Common questions

Call if your question is not covered here.

Overnight, the water sits still in the old pipe and picks up rust from its walls. Once a tap runs for a while, that water is pushed through and the colour fades. The rust inside keeps building, though, and it also marks your washing. We cut out a small section to see how far it has gone.

If rusted galvanised pipe is the cause, new pipe removes it. Oxidised iron can block galvanised pipes and lower the pressure. Some causes new house pipe won’t touch, such as a burst main, hydrant flushing or fire-fighting nearby. A property on a very high hill can have low pressure for that reason alone.

Not always. We can replace the run from the meter to the house first and do the inside pipes later, often when a bathroom is renovated. If the pipes inside are galvanised as well, though, the rust and low pressure won’t fully clear until they’re done too.

Look at a piece you can see without touching it, under the house or near the meter. Galvanised pipe is grey, usually about one inch across, and often dull, rough, scaly or rusty. Copper is orange-brown and polyethylene is black plastic. If you’re unsure, a phone photo of the exposed pipe helps us tell.

Not a council permit. Replacing galvanised supply pipe with another type is notifiable work. That means we do it and register a Form 4 with the QBCC within ten business days of finishing. You get a copy. Repairing a short broken section is minor work and needs no form at all.

Where we work

DR Smith Plumbing and Roofing is based in Clontarf on the Redcliffe peninsula and works across the Moreton Bay area. For Water Pipe Replacement in Clontarf or one of the suburbs below, call 0483 965 800. The same number covers plumbing and roofing jobs.

Map of our Clontarf base. Opens Google Maps

Click map view in Google maps

Roofing services

Steel roof repairs, re-roofing and gutters from the team you already call for plumbing, based in Clontarf.

See all roofing services

SPEAK TO US TODAY!

We look after both your plumbing and your roofing, so there is one number to call for either job: 0483 965 800.