Redcliffe & Moreton Bay Area – Same-Day Service

Hydro Jetting Services

DR Smith Plumbing and Roofing is based in Clontarf and works across the Redcliffe and Moreton Bay area.

15050088
QBCC licence
Redcliffe
On the peninsula
Hydro Jetting Services
How a drain jetter works
How a drain jetter works

Hydro jetting means scouring the inside of a drain with high-pressure water, sent through a hose with a nozzle that drags itself along the pipe. Drain jetting is the right tool for a pipe lined with grease, packed with sand or threaded with fine roots. We put a camera in to show which of those is in the pipe, and whether the real problem is a fault in the pipe that needs a repair instead.

Hydro jetting key facts

  • In drain cleaning, the power available at the nozzle is comparable with high pressure pumps, so it is just as hazardous. That is why we run the jetter ourselves.
  • Jetting a private drain to clear a blockage counts as unblocking sanitary drainage, which Queensland treats as minor work for a QBCC licensee.
  • Past the inspection opening the sewer is Unitywater’s, and its blocked sewer policy keeps private plumbers out of it. We report a fault there to them for you.
  • A relining procedure, as set out by South Australia’s plumbing regulator, starts with a camera inspection to check the pipe is suitable, followed by a high-pressure jet clean.
  • Tree roots caused more of the blockages Unitywater attended in one published year than any other single cause, across Moreton Bay, the Sunshine Coast and Noosa.

When jetting is the right tool

  • A kitchen drain that’s slow again within weeks of being cleared.
  • A drain that still flows but smells, from fat going rancid on the pipe walls.
  • Sand or silt washed in by a summer storm, or by building work next to the pipe.
  • Fine roots that keep finding their way back into the sewer pipe.
  • Camera footage that shows a sound pipe coated in grease or sludge.

Some blockages need a different tool. Hair in a basin or shower comes out faster by hand. A thick mat of roots is usually cut out first, then the pipe is jetted to wash the pieces through. A cracked pipe is looked at first, because the repair may be a different job altogether.

How the jet does its work

The jetter is a pump, a long hose on a reel and a small nozzle on the end. Water leaves the nozzle through jets angled backwards. That backward thrust drives the nozzle forward along the pipe, dragging the hose behind it. The same jets hit the pipe wall all the way around, so they strip what’s stuck to it rather than just opening a hole through the middle.

How a drain gets jetted

On an older drain, or one that keeps blocking, the camera goes in before the jet. We feed it in through an inspection opening, and it shows the state of the pipe and where the build-up or roots sit. If a joint has dropped or a section has cracked, we talk through the repair with you instead.

Where jetting goes ahead, the nozzle goes well into the drain before the pump starts. We cover any nearby gully or opening the hose could escape through. Then the work goes in passes, feeding the hose in and drawing it back slowly. The jets strip the walls on the way out. Once the water runs freely, a second look with the camera shows whether the walls are clean.

What the camera decides

What the camera shows What usually happens Why
Grease or sludge coating a sound pipe Jetting on its own The jet strips the whole wall
Sand or silt after a storm Jetting, flushed through to the sewer Water carries loose sand better than a cable can
Fine roots at a joint Jetting, with the joint noted for repair The roots will return through the same gap
A thick root mass Cut with a drain machine, then jet The cutter breaks the mass, the jet washes it out
A crack, a dropped joint or a collapse A repair or relining is weighed up Jetting clears a pipe but can’t mend it

What makes jetting bigger or smaller

  • What the camera finds. Grease in a short kitchen line is quicker than roots in a long sewer run.
  • Roots. They may need cutting as well as jetting.
  • Access. A drain with no inspection opening that can be reached means getting in through a gully or a toilet.
  • Pipe condition. A damaged pipe changes the plan altogether.

Roots are worth knowing about if big trees grow near your sewer line. Roots seek out water and push into pipes, then keep growing on inside them. That is why a jetted root blockage points to the joint that let them in, and we note that joint for you.

What to know before we arrive

Jetting sits inside Queensland plumbing law. Clearing a blocked sewer drain, by jet or any other way, is unblocking sanitary drainage. That is minor work, and minor work must be done by a QBCC licensed plumber or drainer, which is what we are.

What you can safely do before we come:

  • Make a note of which drains are slow, whether it got worse after rain, and when the line was last cleared.
  • Look for the inspection openings without opening them. They are ground-level caps, sometimes under mulch.
  • Look at the gully grate outside. It should sit clear of the garden, not buried or covered, because that’s where a backed-up drain should spill. If it’s buried, leave it and mention it when you call.
  • If you think a pipe is cracked, stop using that drain and call us.

Jetting is our work, and a drain attachment on a pressure washer is no substitute for it. A water jet piercing the skin is among the common hazards of jetting, and jetting operators are advised to carry a medical alert card.

Have this ready when you ring: the drains affected, the date of the last clear if you know it, and any camera footage from before. Tell us about big trees near the line, and about any building work or storm that came before the trouble.

A jetting job is minor work, so it doesn’t come with a QBCC notice or council paperwork. We leave you with a drain that runs freely and, where we used a camera, a look at the clean pipe afterwards. If the footage shows a fault, we give you a plain account of where it sits and what repairing it involves.

Clearing a blocked drain is minor work, with no form to lodge.

So the law brackets the job at both ends. Jetting your drain is minor work that Queensland reserves for a licensed plumber or drainer, on your side of the inspection opening. Past it, Unitywater’s policy keeps private plumbers out of its sewer altogether.

Jetting, drain cleaning and relining

Hydro jetting is a method, not a whole job. Everyday drain cleaning picks the right tool for the blockage, and jetting is one of them. A CCTV pipe inspection shows whether build-up or damage is the problem. When the camera finds cracks or root-filled joints, pipe relining seals them from inside, and jetting is usually the clean that comes before the liner.

If one of your drains keeps clogging no matter how often it’s cleared, ring DR Smith Plumbing and Roofing on 0483 965 800. Clontarf is where we start from, and jetting work takes us across the peninsula and around Moreton Bay.

Hydro Jetting Services
Call 0483 965 800Request a quote
QBCC 15050088

Common questions

Call if your question is not covered here.

Because the camera shows what the jet would be working on. Build-up on a sound wall is jetting’s job. A crack, a dropped joint or roots through a gap are faults in the pipe, and clearing them doesn’t fix them. Relining starts the same way: a camera inspection to see whether the pipe is suitable, and only then a jet clean.

Neither one wins every time. A drain machine spins a cable with a cutting head, which is good for punching through a blockage and cutting thick roots. A jet cleans the whole wall of the pipe, so it shifts grease and sand that would close up again behind a cable. A root-filled line often takes both, cutting first and jetting after.

No. It strips out the roots inside the pipe, but they got in through a gap in a joint, and the gap is still there. Until that joint is repaired or the pipe is relined, they’ll grow back. Which trees go in near the pipes matters too, and Unitywater publishes a planting guide for that.

No. Clearing a blockage in your own drain is unblocking sanitary drainage, which Queensland classes as minor work. A QBCC licensed plumber or drainer must do it, and that is us, but there’s no council permit and no notice to the QBCC. If the camera then shows damage, the repair is a separate job, and its category depends on what that repair is.

It depends on the drain more than the machine. A short kitchen line coated in grease is a quick job. A long sewer run with roots takes longer, especially if they need cutting first. Add time for a camera look before and after, and for getting in where there’s no inspection opening. Tell us which drains are affected and we can give you a better idea.

Where we work

DR Smith Plumbing and Roofing is based in Clontarf on the Redcliffe peninsula and works across the Moreton Bay area. For Hydro Jetting Services in Clontarf or one of the suburbs below, call 0483 965 800. The same number covers plumbing and roofing jobs.

Map of our Clontarf base. Opens Google Maps

Click map view in Google maps

Roofing services

Steel roof repairs, re-roofing and gutters from the team you already call for plumbing, based in Clontarf.

See all roofing services

SPEAK TO US TODAY!

We look after both your plumbing and your roofing, so there is one number to call for either job: 0483 965 800.